BMW F-Series Front Bumper Support Brackets
$34.99
✓ 5 in stock
These are reinforced aftermarket front bumper support brackets designed to replace the very fragile OEM BMW plastic brackets that commonly crack or break during removal or normal use.
These brackets were personally designed using OEM geometry and 3D printed in PETG Carbon Fiber (PETG-CF) for significantly increased strength and durability compared to factory parts.
๐ง Key Features
- Much stronger than OEM โ PETG-CF is far more impact- and fatigue-resistant than factory plastic
- Direct replacement design using factory mounting locations
- Left & Right set included (L and R marked on parts)
- Designed from OEM BMW reference parts
- BMW Part Numbers: 51117272555 (Left) / 51117272556 (Right)
- Ideal for daily drivers, track cars, or vehicles with frequent bumper removal
โ ๏ธ IMPORTANT INSTALLATION NOTE โ PLEASE READ
Because these brackets are thicker and stronger than the original BMW brackets, longer mounting screws are required for installation.
- Factory screws will NOT be long enough
- Hardware is NOT included
- Buyer must source appropriately longer screws prior to installation
๐ฆ What's Included
- (1) Left front bumper support bracket
- (1) Right front bumper support bracket
๐งช Material
- PETG Carbon Fiber (PETG-CF)
- Stronger than standard PETG
- Better heat resistance than PLA
- Excellent dimensional stability
๐ธ Photos
Listing photos include the PETG-CF printed brackets, factory BMW OEM brackets for comparison, and the CAD model used for design verification.
๐ Vehicle Fitment
Fits BMW F-Series models that use OEM bumper support brackets:
- BMW F22 โ 2-Series Coupe (including M235i)
- BMW F23 โ 2-Series Convertible
- BMW F20 โ 1-Series Hatchback
- BMW F21 โ 1-Series Hatchback
Fits vehicles originally equipped with BMW part numbers 51117272555 / 51117272556. Buyer is responsible for verifying fitment before purchase.
โ Disclaimer
- This is an aftermarket 3D-printed part, not a BMW OEM component
- Minor surface layer lines typical of 3D printing may be present
- Designed for structural function, not cosmetic visibility
If you have any questions about fitment before purchasing, feel free to message me.